Ethernet cables (RJ45) for data communication is the most prevalent wired communication technology used in military, industry and home applications.
EMP surges that occur over data lines can lead to data corruption, delay in transmission or equipment damage in the long run.
EMP Surge Protectors are HEMP filters installed on data lines that help to isolate the equipment from the external EMP threats.
These filters are designed to withstand all the E1, E2 and E3 pulse types. These components are subjected to the PCI test and must match the shielding effectiveness as stated in MIL-STD-188-125.
Voltage Range
± 3VDC peak signal voltage between Wire Pairs 1-2, 3-6, 4-5 and 7-8.
Application
Defence Equipment
Features
Applications
Telephone and Signal lines for various application areas:
What EMIS Offers
EMIS range of EMP Surge Protectors/Filters for Ethernet (RJ45) Data Lines provide very effective noise attenuation for a wide range of military and industrial applications.
These Filter are classified under unrestricted lines of Intra-site of MIL STD- 188-125-1 of Data and Tested for the same. They meets the insertion loss requirements and provide protection at every pair.
Standards :
MIL-STD-188-125-1&2 (E1 & E2 Pulse)
E1: Input 1.8kA, Residual: <2.5A
E2: Input 250A, No Damage
IEC 61000-6-2
The Filters are designed in the bulk head which gives complete isolation between unprotect and protected sides.
MIL circular connectors are provided at the input side of the filters which helps in easy termination and protection.
Mounting, Construction, Ratings
Rated Voltage : ± 3VDC peak signal voltage between Wire Pairs 1-2, 3-6, 4-5 and 7-8.
Data Rate : 10/100/1000 Mbps